TBCP
Sets the PostScript communications protocol to TBCP.
Binary
Sets the PostScript communications protocol to Binary.
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
Port Status
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off
and then on again.
Values:
Disable
Disables the USB interface.
Enable*
Enables the USB interface.
Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
Auto
Sets the PostScript communications protocol automatically.
Standard
Sets the PostScript communications protocol to Standard.
BCP
Sets the PostScript communications protocol to BCP.
TBCP*
Sets the PostScript communications protocol to TBCP.
Binary
Sets the PostScript communications protocol to Binary.
System Settings
Use System Settings to configure a variety of printer features.
Epson AcuLaser C2900 Series User’s Guide
Using the Operator Panel Menus 119
To Next Page
Loading...
