Epson AcuLaser C2900N - Protrudent;Bumpy Paper; Adjusting Color Registration; Performing Auto Adjust

Protrudent/Bumpy Paper
Problem Action
Printed surface got protrudent/bumpy. Clean up the fuser unit.
1. Load one sheet of paper on the SSF, and then print a solid image all over paper.
2. Load the printed sheet with the side to be printed on facing down, and then print
a blank sheet of paper.
If the problem persists, contact the Epson local representative office or an
authorised dealer.
Adjusting Color Registration
This section describes how to adjust the color registration when you first install the printer or after
moving it to a new location.
Performing Auto Adjust
Auto Adjust allows you to correct the color registration automatically.
The Operator Panel
1. Press the (Menu) button.
2. Select Admin Menu, and then press the
button.
3. Select Maintenance Mode, and then press the
button.
4. Select Adjust ColorRegi, and then press the
button.
Epson AcuLaser C2900 Series User’s Guide
Troubleshooting 182