Epson AcuLaser C2900N - Page 44

1. Turn on the printer.
Ensure that Ready message appears on the LCD panel.
2. On the operator panel, press the (Menu) button.
3. Select Admin Menu, and then press the
button.
4. Select Wired Network, and then press the
button.
5. Select TCP/IP, and then press the
button.
6. Select IPv4, and then press the
button.
7. Select Get IP Address, and then press the
button.
8. Select Panel, and then press the
button.
9. Ensure that the message Restart Printer to apply setting appears, and then press any
button.
10. Press the
button to select IP Address, and then press the button.
The cursor is located at the first octet of the IP address.
11. Specify the value of the IP address using the
or button.
12. Press the
button.
The cursor moves to the next octet.
13. Repeat steps 11 to 12 to set all of the digits in the IP address, and then press the
button.
14. Ensure that the message Restart Printer to apply setting appears, and then press any
button.
15. Press the
button to select Subnet Mask, and then press the button.
The cursor is located at the first octet of the subnet mask.
16. Specify the value of the subnet mask using the
or button.
17. Press the
button.
Epson AcuLaser C2900 Series User’s Guide
Network Basics 44