❏ Paper that has been printed on with a monochrome/color laser printer/copier
❏ Paper that has been printed on with a heat-transfer printer
❏ Paper that has been printed on with any other printer or fax machine
❏ Dusty
❏ Wet (or damp)
Note:
Keep media between 35% and 85% relative humidity. Toner does not adhere well to moist or wet
paper.
❏ Layered
❏ Adhesive
❏ Folded, creased, curled, embossed, warped, or wrinkled
❏ Perforated, three-hole punched, or torn
❏ Too slick, too coarse, or too textured
❏ Different in texture (roughness) on the front and back
❏ Too thin or too thick
❏ Stuck together with static electricity
❏ Composed of foil or gilt; too luminous
❏ Heat sensitive or cannot withstand the fusing temperature (205˚C [401˚F])
❏ Irregularly shaped (not rectangular or not cut at right angles)
❏ Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
❏ Acidic
❏ Any other media that is not approved
Thick Stock
Paper thicker than 90 g/m is referred to as thick stock. You can print continuously with thick stock.
However, this could affect the media feed, depending on the media quality and printing environment.
If problems occur, stop the continuous printing and print one sheet at a time.
AcuLaser C3900 Series User’s Guide
Media Handling 61
To Next Page
Loading...
