174
Note: You cannot adjust the black levels while projecting a test pattern, and you may not be able to
adjust the black levels correctly if the Geometry Correction settings are set too high. The brightness
and tone of the overlapping areas may differ from the rest of the image even after adjusting the black
level.
1. Press the Menu button.
2. Select the Multi-Projection menu and press Enter.
3. Select the Black Level setting and press Enter.
Note: The Black Level setting is displayed only if Edge Blending is enabled and at least one (top,
bottom, left, right) edge is set to On.
4. Select the Color Adjustment setting and press Enter.
You see a screen based on the Top Edge, Bottom Edge, Right Edge, and Left Edge settings you
selected for the Edge Blending setting.
To Next Page
Loading...
