55
Note: For additional features supported by software, connect your document camera to your computer
instead of the projector. See the document camera manual for details.
Parent topic: Projector Connections
Connecting a Printer to the Control Pad
You can connect an Epson printer or all-in-one device to the USB-A port on the control pad (BrightLink
1485Fi+) and use it to print your projected and annotated content. Make sure the printer meets the
control command requirements.
Note: You can connect a wireless printer by selecting Network Printer as the Print > Printer setting in
the Interactive menu.
1. Connect a USB cable to one of the USB-A ports on the projector and to the USB-B port at the top of
the control pad.
2. Connect another USB cable to the USB-A port on the bottom of the control pad. Make sure the cable
is no longer than 16.4 ft (5 m).
3. Connect the other end of the cable to the USB Type B port on the printer.
Parent topic: Projector Connections
Related references
Interactive Settings - Interactive Menu
Connecting Multiple Projectors of the Same Model
You can connect up to four projectors of the same model in the same room to project a single unified
image (BrightLink 1485Fi+).
Note: The interactive features are available only when connecting two projectors (DuoLink). The two
projectors must be synchronized using a stereo mini cable and a USB-A to USB-B cable.
1. Connect the computer and the projectors using HDMI cables as shown.
To Next Page
Loading...
