Epson BrightLink 1485Fi+ - Using the Projector Menu Displays

339
Power light Status light Laser light Temp light Status and solution
Varies Varies Fast
flashing
orange
Fast flashing
orange
The batch setup file is corrupt or the
USB flash drive is connected
incorrectly. Disconnect the USB flash
drive and turn off the projector.
Unplug the projector, plug it in again,
and try again.
Fast flashing
blue
Fast flashing
blue
Fast
flashing
orange
Fast flashing
orange
Writing the menu settings has failed
and an error in the projector's
firmware has occurred. Turn the
projector off, unplug it, and contact
Epson for help.
Wireless LAN Light Status
The Wireless LAN light indicates the following:
• Blue: Wireless LAN is available and operating normally
• Flashing blue (quickly): Connecting to a device
• Flashing blue (slowly): An error has occurred. Turn off the projector and restart it
• Off: Wireless LAN is not available. Make sure the Wireless LAN Power setting is set to On in the
projector's Management menu
Note: If the lights display a pattern not listed in the tables above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
Related references
Where to Get Help (Latin America)
Feature Settings - Operation Menu
Administration Settings - Management Menu
Using the Projector Menu Displays
The projector displays descriptions in the menu system to help you navigate the projector's settings. The
descriptions appear on the right side of the screen as you scroll the menu settings.
Parent topic: Solving Problems