176
The selected line is displayed in orange.
13. Use the arrow buttons to adjust the boundary line position and press Enter.
14. Use the arrow buttons to select an adjustment point and press Enter.
Note: You can change the number of adjustment points displayed by changing the Points setting in
the Area Correction menu.
The selected point turns orange.
15. Use the arrow buttons to move the point.
16. To move another point, press the Esc button and repeat the previous two steps.
17. To move another boundary line, press the Esc button repeatedly until you can select a boundary
line.
18. When you are finished, press the Esc button until you see a confirmation message. Select Yes and
press Enter.
19. When you are finished, press the Menu button.
To Next Page
Loading...
