254
2. Select the Interactive menu and press Enter.
3. Select Directory and press Enter.
4. Select the following options as necessary:
• Directory Access Function specifies whether to search an active directory server for user names
and email addresses.
• LDAP Server let you enter the IP address or fully qualified domain name (FQDN) for the LDAP
server. You can enter up to 64 alphanumeric characters. Do not use spaces or the following
symbols: " * + , : ; < = > ? [ \ ] ` |. If you specify an FQDN, you must configure a DNS server.
Note: You cannot use the following IP addresses: 127.x.x.x, 192.0.2.x, or 224.0.0.0 to
255.255.255.255 (where x is a number from 0 to 255).
• Port Number lets you enter a port number for the LDAP server. The default port is 389. Specify
"3268" to search the global catalog.
• Authentication lets you set the type of authentication expected by the LDAP server. If you are
using Digest-MD5 or Simple authentication and the LDAP Server setting is set to an IP address,
you must enable reverse DNS lookup on the DNS server.
To Next Page
Loading...
