264
Selects all objects and images in a rectangular area. Specify the area by drawing on the
projection surface. You can also tap an object or image to select it.
• To cancel the current selection, tap an empty area on the board.
• Drag the edge of the area to enlarge or reduce the object or image.
• Drag the icon at the top of the area to rotate the selected object or image.
• To perform the following operations, select the icon at the bottom right of the selected
object or image:
• Duplicate
• Copy
• Paste (tap the location where you want to paste)
• Delete
Undoes the previous action.
Restores the action that was previously undone.
Clears all drawings from the displayed page.
Disables touch input temporarily to prevent unintended operation. Tap again to enable touch
operation.
Stops screen sharing (available only when projecting a shared image).
Toggles the PC Interactivity setting off and on. Set the PC Interactivity setting to On to
control the computer using the interactive pens and/or your fingers (not available when
projecting a shared image).
Hides the toolbar. Tap again to show the toolbar.
Follow these guidelines when using the annotation toolbar:
• To paste an image, you need to use the same pen that you used to cut or copy the image.
• Drawn objects are displayed at the front of the projected page.
• If objects or images are moved out of the projected screen, you may not be able to select them.
Parent topic: Using BrightLink Without a Computer
To Next Page
Loading...
