Publishing Discs 118
Taking Out Discs
Follow the steps below to take out the published/read discs from the stackers.
For PP-100III/PP-100AP
c
Caution:
If you select stacker 4 as the output stacker in Standard mode or External Output mode,
n Do not yank stacker 4 when pulling it out to remove published discs.
n Do not pull out stacker 4 when the stacker 4 LED is flashing fast. Discs may be damaged.
1. Open the disc cover (only for output to stacker 2 or 3), and take out the stacker.
2. Take out the published/read discs from the output stacker.
Note:
n Once the output stacker becomes full, the job is paused. The job is resumed automatically if you
take out the published discs from the stacker.
n Be sure to let printed discs dry completely before using them or touching the printed surface.
Allow Epson specified discs to dry for at least 1 hour and other types of discs for at least 24 hours.
n If the print position is misaligned, adjust it using the printer driver. For details, refer to the printer
driver Help.
n If the ink smears, adjust the color saturation. For details, refer to the printer driver Help.
Stacker 2 Stacker 3 Stacker 4
To Next Page
Loading...
