Publishing Discs 27
Drive Settings (Only for PP-100III/PP-50II)
Drive to be used (Only for PP-100III)
Select Drive to Use from the following.
Use Both
Use both drive 1 and 2 to write/read data. Jobs will be efficiently processed by using 2 drives. If
trouble occurrs on either drive and it cannot write data, other drive will be used automatically.
Use Drive 1 Only
Use only drive 1.
Use Drive 2 Only
Use only drive 2.
Number of write retries (except for Read Back mode)
Select 0 to 9 for the Number of write retries.
The Number of write retries is a setting to retry writing if a write error occurs.
Setting the Number of write retries will enable the job to continue without pausing if a write
error occurs.
No. of read back errors allowed (only for Read Back mode)
Select 0 to 9 for the No. of read back errors allowed.
Setting the No. of read back errors allowed will enable jobs to continue without pausing until the
set number of read back errors continuously occur. When a read back error occurs, the disc will
be ejected as an error disc and reading the next disc will be processed.
Continue publishing regardless of the occurrence of read back errors (only for Read
Back mode)
If you check this checkbox, no matter how many times a read back error occurs, the jobs will
continue without pausing. When a read back error occurs, disc will be ejected as an error disc
and reading the next disc will be processed.
To Next Page
Loading...
