Publishing Discs 119
n When publishing discs using Batch mode, the number of discs output to stacker 3 is not always
the same as the number of discs loaded into stacker 2. Also, the number of discs does not always
become 50. The same applies to the number of discs output to stacker 2. For Batch mode, the
output stacker switches to stacker 2 when the ejected discs accumulated in stacker 3 reach the
height limit. As a result, the number of discs output to the stacker depends on the thickness of the
discs used.
For PP-50II
1. Open the disc cover.
2. Take out the stacker only when the output stacker is stacker 2.
3. Take out the published/read discs from the stacker. The output stacker differs according to
the publish mode. Refer to the following table.
Note:
n Once the output stacker becomes full, the job is paused. The job is resumed automatically if you
take out the published discs from the stacker.
n Be sure to let printed discs dry completely before using them or touching the printed surface.
Allow Epson specified discs to dry for at least 1 hour and other types of discs for at least 24 hours.
n If the print position is misaligned, adjust it using the printer driver. For details, refer to the printer
driver Help.
n If the ink smears, adjust the color saturation. For details, refer to the printer driver Help.
Output stacker Publish mode Number of discs
Stacker 2 Standard mode
Read Back mode
Up to about 50 discs
Stacker 3 Standard mode
Low-volume mode
Up to about 20 discs
Stacker 2 Stacker 3
To Next Page
Loading...
