Epson Disc producer PP-100III - The Product Is Not Recognized (Only for PP-100 III); Maintenance Box Nearly Full Message Is Displayed by the Software; (Only for PP-100 III;PP-100 AP); Ink Pad Nearly Full Message Is Displayed by the Software (Only for PP-50 II)

Troubleshooting 168
The Product is not Recognized (Only for PP-100III)
If the product is not recognized with EPSON Total Disc Setup after if even either one of the drives
is replaced, the drive may not be inserted correctly. Turn off the product, disconnect the power
cable from the wall outlet, and then firmly push the replaced drive completely inside.
Maintenance Box Nearly Full Message is Displayed by the Software
(Only for PP-100III/PP-100AP)
The maintenance box is nearly full.
& See “Replacing the Maintenance Box (Only for PP-100III/PP-100AP)” on page 141.
Ink Pad Nearly Full Message is Displayed by the Software (Only for
PP-50II)
Ink pad is nearly full. Please have an authorized Epson service center replace the ink pad right
away. The pad is nearly full, and the unit will stop functioning when the pad becomes full. Do not
attempt to service the unit yourself.
& See “Replacing the Ink Pad (Only for PP-50II)” on page 142.