Epson DS-360W User Manual

1. Set the connection mode switch on the scanner to .
Note:
Even though the PIN code method sets up the scanner for Wi-Fi network, you need to set the connection mode switch to
in this step.
2. Hold down the button on the scanner and turn it on.
Continue holding down the
button until the Ready and lights on the scanner ash alternately.
3. Use your computer to enter the PIN code (an eight-digit number) on the label stuck to the bottom face of the
scanner into the access point within two minutes.
When the Ready and
lights on the scanner stay on, Wi-Fi setup for the scanner is complete.
User's Guide
Network Settings
87

Epson DS-360W Specifications

General

Optical Resolution	600 dpi
Scan Speed	Up to 25 ppm/50 ipm
ADF Capacity	20 sheets
Maximum Resolution	1200 dpi
Supported Operating Systems	Windows, Mac OS
Connectivity	Wi-Fi
Interface	USB