a
SNMP should be managed by a network administrator or someone
who is familiar with the network.
To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
The SNMP Agent for this projector complies with version 1
(SNMPv1).
The managing function using SNMP cannot be used via wireless
LAN in Quick mode.
Up to two destination IP addresses can be saved.
ESC/VP21 Commands
You can control the projector from an external device using ESC/VP21.
Command list
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
The main contents are listed below.
Item Command
Power ON/OFF On PWR ON
Off PWR OFF
Signal selection Computer1 Auto SOURCE 1F
RGB SOURCE 11
Component SOURCE 14
Item Command
Computer2 Auto SOURCE 2F
RGB SOURCE 21
Component SOURCE 24
HDMI SOURCE 30
Video SOURCE 41
S-Video SOURCE 42
USB Display SOURCE 51
USB SOURCE 52
LAN SOURCE 53
A/V Mute ON/OFF On MUTE ON
Off MUTE OFF
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
For more details, contact your local dealer or the nearest address provided
in the Epson Projector Contact List.
s Epson Projector Contact List
Cable Layouts
Serial Connection
Connector shape: D-Sub 9-pin (male)
Monitoring and Controlling
106
To Next Page
Loading...
Need help?
General
Weight and Dimensions
