Submenu Function
IP Address Dis-
play
To prevent the IP address from being displayed on Network Info
in the Network Menu and on the LAN Standby screen, set this to
Off.
Mail Menu
When this is set, you receive an email notification if a problem or warning
occurs in the projector.
s
"Using the Mail Notification Function to Report Problems" p.104
Submenu Function
Mail Notification
Set to On to send an email to the preset addresses when a problem
or warning occurs with a projector.
SMTP Server
You can input the
IP address
g
for the SMTP server for the
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Submenu Function
Port Number
You can input the port number for the SMTP server. The default
value is 25. You can input numbers between 1 to 65535.
Address 1 Set-
ting/Address 2
Setting/Address
3 Setting
You can input the email address of the destination to send the
notification email to. You can register up to three destinations.
You can enter up to 32 single-byte alphanumeric characters for
the email address. The following characters cannot be used: " ( ) , ;
< > [ \ ]
The address for destination 1 is the mail notification sender's
address.
You can select the problems or warnings to be notified about by
email. When the selected problem or warning occurs in the
projector, an email is sent to the specified destination address
notifying that a problem or warning has occurred. You can select
multiple items from the displayed items.
List of Functions
131
To Next Page
Loading...
Need help?
General
Weight and Dimensions
