Settings Menu
Submenu Function
Keystone
You can correct keystone distortion.
• When H/V-Keystone is selected:
Adjust V-Keystone and H-Keystone to correct horizontal
and vertical keystone distortion.
You can also make the following settings.
For EB-W16: Set Auto H/V-Keystone to On or Off.
For EH-TW550/EH-TW510: Set Auto V-Keystone and H-
Keystone Adjuster to On or Off.
• When Quick Corner is selected:
Select and correct the four corners of the projected image.
s "Quick Corner" p.36
Control Panel
Lock
You can use this to restrict operation of the projector's control
panel.
s "Restricting Operation (Control Panel Lock)" p.67
Submenu Function
Pointer Shape
You can select the shape of the pointer.
Pointer 1:
Pointer 2:
Pointer 3:
s "Pointer Function (Pointer)" p.60
Power Consump
tion
(For EB-W16)
You can set the lamp brightness to one of two settings.
Select ECO if the images being projected are too bright, such as
when projecting images in a dark room or onto a small screen.
When ECO is selected, the power consumption and the lamp's
operating life are changed as follows, and fan rotation noise
during projection is reduced.
Electrical consumption: about 17% decrease, lamp life: about
1.25 times longer
When using at high altitude or in locations subject to high
temperatures, you may not be able to change settings.
Power Consump
tion
(For EH-TW550/
EH-TW510)
You can set the lamp brightness to one of two settings. Select Low
if the images being projected are too bright, such as when
projecting images in a dark room or onto a small screen. When
Low is selected, the power consumption and the lamp's operating
life are changed as follows, and fan rotation noise during
projection is reduced.
Electrical consumption: about 17% decrease, lamp life: about
1.25 times longer
When using at high altitude or in locations subject to high
temperatures, you may not be able to change settings.
Volume
You can adjust the volume. Setting values are saved for each
source.
Remote Receiver
You can limit the reception of the operation signal from the
remote control.
When set to Off, you cannot perform any operations from the
remote control. If you want to make operations from the remote
control, hold down the [Menu] button on the remote control for
at least 15 seconds to reset the setting to its default value.
List of Functions
77
To Next Page
Loading...
Need help?
General
