122
MaintenanceMaintenance
User’s Guide
Loosen the two lamp fixing screws.
Use the screwdriver that is supplied with the spare lamp or your
own cross head screwdriver to loosen the two lamp fixing
screws that are securing the lamp to the projector.
l
Take out the old lamp.
Hold the lamp by its knob as shown below, and pull out the
lamp. If the lamp is broken, contact your local dealer for further
advice. If replacing the lamp by yourself, be careful to avoid
pieces of broken glass.
Install the new lamp.
Hold the lamp so that it faces the correct way to fit into the
projector, and then insert the lamp until it clicks into place and
tighten the two lamp fixing screws.
3
4
5
To Next Page
Loading...
