71
Adjusting Projected Images Manually
User’s Guide
When vertical keystone correction is carried out automatically or manually,
the height of the projected images will become shorter. Use the height
correction function to adjust the height of the projection area.
The height correction function is accessible from the configuration menu.
This cannot be set when horizontal correction is carried out.
PROCEDURE
Press the [Menu] button on either the remote control
or the projector's control panel.
Then select "Setting" - Keystone" - "H/V-Keystone" -
"Horz./Vert./Height" - "Height" from the configuration
menu.
For details, refer to "Using the Configuration Menus" sp.87
Tilt the [ ] button on the remote control to the left or
right, or press the [ ] or [ ] buttons on the
projector's control panel to correct the height while
viewing the projected images.
When the adjustment is complete, press the [Menu]
button on the remote control or the projector's
control panel to close the configuration menu.
Height Correction
1
2
3
To Next Page
Loading...
