133
List of ESC/VP21 CommandsList of ESC/VP21 Commands
User’s Guide
* The [USB Type A] port (EMP-835 only) cannot be used as a USB hub.
USB Connection Setup
In order to control the projector using ESC/VP21 commands via a USB
connection, the following preparations must be carried out.
PROCEDURE
Download the USB driver (USB-COM Driver) from the
EPSON website to your computer.
The URL is as follows.
http://esupport.epson-europe.com/downloads/en/
Install the downloaded USB driver on your computer.
Read the instructions displayed on the download screen.
Change the "COM Port" setting in the "Extended"
menu to "USB".
Turn the projector off.
Turn the projector's power back on.
Once the projector's power has turned back on, communication
via a USB connection will then be possible.
USB Connection
• Connector shape : USB(type B)
<At projector>
<At computer>
Type B
USB
1
2
3
4
5
To Next Page
Loading...
