33
User’s Guide
Turning the Projector On
Turn the power on to start projecting images.
Connecting the Power Cable
PROCEDURE
Check that the power is turned off for the projector
and, if necessary, that all components are connected
to the projector.
Connect the computer or other video source to the
projector. sp.19, p.25
Remove the lens cover.
Place your fingers against the [ ] and [ ] on the lens cover
and press in while pulling the lens cover forward to remove it.
Connect the accessory power cable to the projector.
Check that the power connector is facing the same way as the
power inlet on the projector, and then insert the power cable
connector securely into the projector.
Connect the other end of the power cable to an
earthed electrical outlet.
Caution
Be sure to read the Safety Instructions/World-Wide Warranty Terms
before projecting images.
1
2
3
4
5
TIP
When "Direct Power ON" in the configuration menu is set to "ON",
the projector's power can be turned on simply by connecting the
power cable.
The default setting is "OFF". s"Extented" - "Operation" p.85
To Next Page
Loading...
