48
Preventing Theft (Password Protect)Preventing Theft (Password Protect)
User’s Guide
The password entry screen will not be displayed at all when the power is
turned on until the length of time that has been set has elapsed. When the
set length of time has elapsed, the password entry screen will be displayed
each time the power is turned on. The length of time referred to here is the
total illumination time for the projector's lamp from the point when the
projector's menu is closed.
If "Timer" is set to "0", the password entry screen will be displayed each
time the power plug is disconnected and reinserted from the electrical
outlet. If the projector's power on when it is in standby mode, the password
entry screen will not be displayed.
If you try to carry out any of the following user's logo-related
operations, a message will be displayed, and the settings cannot be
changed. To change any of the settings, first set "User's Logo
Protect" to "OFF".
sp.50
• Capturing a user's logo
• Changing the "Extended" - "Display" - "Display Background" menu
setting or "A/V Mute" setting to "Black" or "Blue" from "Logo", or to
"Logo" from "Black" or "Blue".
• Changing the "Extended" - "Display" - "Startup Screen" menu setting
("ON" or "OFF")
Entering a Password with the Remote Control
Press the [Num] button on the remote control to enter the password.
If you press the [Num] button, it will light up and the remote control
buttons will change to numeric keypad mode so that you can enter
numbers.
If you do not press any button for about 10 seconds while numeric keypad
mode is active, or if you press the [Num] button once more, the [Num]
button will turn off and numeric keypad mode will be cancelled.
If the "Timer" Setting is for One Hour or More
If "User's Logo Protect" is Enabled (ON)
Remote control
The buttons inside the box will switch
to numeric keypad mode while the
[Num] button is lit.
Numeric keypad
To Next Page
Loading...
