28
User’s Guide
Playing Sound from Connected Equipment
The projector has a built-in speaker with a maximum output of 5 W. You can
output sound from the connected equipment (such as a computer or VCR)
through the projector's built-in speaker if the equipment has an audio output
port.
The [Audio] port to use is the port that is in the same box as the port being
used to input the image signals, except when component video signals are
being input.
If component video signals are being input from a DVD player or some
other equipment to the [Computer 1 (or 2)/Component] port, you can use
one or other of two combinations shown below depending on the audio
cable type you use.
When component video images are projected, the connected port is
automatically recognized regardless of which [Audio] port is being used,
and the sound is then output from the projector's built-in speaker.
To audio output ports
To [Audio] port
RCA audio cable
(commercially-available)
red
white
To audio output port
Audio cable
(commercially-available)
If the image signals are being input to
the [Video] port
When image signals are being
input to the [Computer 1 (or 2)/
Component] port
To [Audio] ports
When Component Video Signals are being Input
When connecting to the
[Computer 2/
Component] port
When connecting to the
[Computer 1/
Component] port
TIP
• You can adjust the volume after projection has started. sp.46
• If using a commercially- available 2RCA (L/ R)/ stereo mini- jack
audio cable, use one that is marked as "No resistance".
To Next Page
Loading...
