22
Connecting to a Computer
User’s Guide
Once the connection has been made, the mouse pointer can be operated as
follows.
Moving the mouse pointer
Tilt the [ ] button on the remote
control to move the mouse pointer in
the direction of tilt.
Left click
Press the [Enter ( )] button.
If you press the [Enter ( )] button twice
in rapid succession, it has the effect of
a double-click.
Right click
Press the [Esc ( )] button.
Drag and drop
When you hold down the [Enter ( )]
button for approximately 1.5 seconds,
the button will light and drag and drop
mode will be enabled. In this mode,
you can carry out drag operations by
tilting the [ ] button.
Press the [Enter ( )] button at the
desired position to drop the items being
dragged.
Drag and drop mode can also be
enabled in the same way by pressing
the [Esc ( )] button for approximately
1.5 seconds. This operation allows
right click dragging and dropping.
TIP
• If the mouse button settings have been reversed at the computer, the
operation of the remote control buttons will also be reversed.
• The wireless mouse function of the remote control cannot be used
while a warning message is being displayed or while the following
functions are being used.
· While Quick Setup is running
· While Password Protect is being set
· While a configuration menu is being displayed
· While a help menu is being displayed
· While the pointer function is being used
· While a sub-screen has been set using the PinP function
· While the E-Zoom function is being used
· While a Quick Corner setting has been made
· While an image is being displayed in real display using the resize
function
· While the preview function is being used
· While a user's logo is being captured
· While Wall Shot is enabled
To Next Page
Loading...
