37
Turning the Projector On
User’s Guide
*1 Only changes when using the EMP-835.
sEasyMP Operation Guide and the EasyMP Network Setup Guide for details on using EasyMP.
*2 The input signal will not change to the next signal source unless a button is pressed while the current signal name is still being displayed on the
screen.
*3 The status selected using "Signal" - "Computer1 (or 2) Input" in the configuration menu will be displayed inside brackets.
Source
Button to press
On-screen display
Remote
control
Projector
EasyMP
*1
[EasyMP]
The source changes in the following order each time [Computer/Component]
is pressed.
*2
EasyMP
Computer1/Component [Comp1]
Computer1 (Auto)
Computer1 (RGB)
*3
Computer1 (Component Video)
Computer2/Component [Comp2]
Computer2 (Auto)
Computer2 (RGB)
*3
Computer2 (Component Video)
S-Video [S-Video] The source switches alternately as follows.
*2
S-Video
Video
[Video]
Video
Computer1/Component
Computer2/Component
*
1
S-VideoVideo
To Next Page
Loading...
