Network Software 105
Network Guide
Unix:
❏ Netscape Navigator version 4.05 or later
About Web browser setting
When running EpsonNet Config with Web Browser, be sure not to use a proxy server to
access the Internet. If the Access the Internet using a proxy server check box is
selected, you cannot use EpsonNet Config with Web Browser. Use the following steps to
clear the Access the Internet using a proxy server check box.
1. Right-click the Internet Explorer icon on the desktop, and then select Properties.
2. Click the Connection tab.
3. Clear the Access the Internet using a proxy server check box.
Configuring the Network Interface Using Web-Based EpsonNet
Config
After you have assigned an IP address to the network interface using EpsonNet
EasyInstall, EpsonNet Config for Windows or Macintosh, or the arp/ping command, you
can configure the network interface using Web-based EpsonNet Config.
Note:
❏ A Web browser must be installed on your computer.
❏ TCP/IP must be correctly set for the computer and the network interface.
❏ Do not run both EpsonNet Config for Windows or Macintosh and Web-based EpsonNet Config
at the same time.
❏ Your browser may restrict some characters you can use. For details, see your browser or
operating system documentation.
Note for users of printers supporting NetWare queue-based printing:
If you are using the dial-up environment without running NetWare, select Disable on the NetWare
screen. If Enable is selected, the extra account may be charged when you are using the dial-up
router.
Follow the steps below to change the IP address using EpsonNet Config.
1. Turn on your printer.
2. Run EpsonNet Config using one of the following ways.
To Next Page
Loading...
