Network Software 117
Network Guide
LJ4 Emulation
GL2 Emulation
Items Explanations
Emulation Select LJ4.
Font Source Select the default font source.
Font Number Type the default font number from the default font source.
Pitch Type the default font pitch if the font is scalable and
fixed-pitch.
Height Type the default font height if the font is scalable and
proportional.
Symbol Set Select the default symbol set.
Form Type the number of lines for the selected paper size and
orientation.
Source Symbol Set Available only when an optional font ROM is installed.
Dest Symbol Set Available only when an optional font ROM is installed.
CR Function Select CR (carriage-return) or CR+LF
(carriage-return/line-feed) operation whenever the print
position exceeds the right margin.
LF Function Select LF (line-feed) or CR+LF (carriage-return/line-feed)
operation to add a line feed to each carriage return it
receives.
Tray Assign Select the tray assigning from 4, 4K, or 5S. When 4, 4K, and
5S are selected, LaserJet 4 Compatible, LaserJet
4000/5000/8000 Compatible, and LaserJet 5 Si
Compatible are available respectively.
Set button Saves any changes.
Refresh button Clears any changes and reloads the previous settings.
Items Explanations
Emulation Select GL2.
GL-Mode Select whether the emulation is similar to the GL/2 or the
HP LaserJet 4 emulation of the GL/2.
Scale Select whether the output from the software is scaled,
and if so, how the scale factor is calculated: based on the
output paper size of the software application.
Origin Select whether the logical origin of the “plotter” is from
the corner or the center of the paper.
Pen Select the logical “pen” which “plots” the drawing.
To Next Page
Loading...
