Epson EPL-6200 - Page 118

Network Software 118
Network Guide
ESCP2 and FX Emulation
End Select the way in which lines end.
Join Select the way in which lines are joined.
Pen (0 to 6) Select the thickness of the seven “pens” used to make the
printout.
Set button Saves any changes.
Refresh button Clears any changes and reloads the previous settings.
Items Explanations
Emulation Select ESCP2 or FX.
Font Select a font which is used for printing.
Pitch Select a character pitch.
Condensed Use this option to change the character spacing.
T. Margin Use this option to specify the distance from the top of the
sheet to the baseline of the first printable line.
Text Use this option to set the page length in lines.
CG Table Use the character generator table option to select the
graphics character table, or the italics table.
Country Use this option to select one of the international symbol
sets.
Auto CR Use the automatic carriage return option to perform a
carriage-return line-feed (CR-LF) operation whenever the
print position exceeds the right margin.
Auto LF When you set AutoLF to Off, the printer does not send an
automatic line feed (LF) command with each carriage
return (CR). When on, the printer adds a line feed to each
carriage return it receives.
Bit Image With Bit Image set to Dark or Light, your printer can
correctly emulate the graphics densities set with the
printer command. When you select Dark, the bit image
density is high. When you select Light, the bit image
density is low.
Zero Char Select whether the printer prints a slashed zero or an
unslashed zero.
Set button Saves any changes.
Refresh button Clears any changes and reloads the previous settings.