Tips for Administrator 169
Network Guide
Note:
❏ To use Auto, a DHCP server must be correctly configured on the network. See the online
help of your operating system for detailed instructions.
❏ Choose PING only when setting the IP address using the arp/ping command.
6. Press the Up or Down button until IP = xxx.xxx.xxx.xxx appears. Press the Enter
button.
7. Press the Up or Down button until the desired value appears. Then press the Enter
button to set the value.
Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default gateway.
8. Press the Start button to exit the control panel menus.
9. Turn off your printer and then turn it back on. Be sure to wait until the initialization is
complete.
Print a network status sheet to confirm the new IP address.
Note:
❏ You must first set the IP address before using EpsonNet Config with Web Browser.
❏ See the User’s Guide for more information about settings on the printer’s control panel.
Network Menu
These items are used to make network settings on the printer’s control panel.
Item Settings (default in bold)
Network I/F On, Off
Get IPAddress Panel, Auto, PING
IP 0.0.0.0 to 255.255.255.255
SM 0.0.0.0 to 255.255.255.255
GW 0.0.0.0 to 255.255.255.255
NetWare On, Off
AppleTalk On, Off
MS Network On, Off
Bonjour On, Off
Link Speed Auto, 100 Full, 100 Half, 10 Full, 10 Half
Buffer Size Normal, Maximum, Minimum
To Next Page
Loading...
