Epson PERFECTION V700 PHOTO - Disassembly Procedure

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 38
4.2 Disassembly Procedure
This section illustrates how to remove the main components of this product. Unless otherwise specified, the reassembly procedure is the reverse of the
disassembly procedure. For additional assembly illustrations, refer to the exploded diagrams in the Appendix.
The following flowchart shows the disassembly procedure step-by-step, and the section and page number where the procedure is described.
Figure 4-2. Disassembly Flowchart
Start
Removing the Upper Housing
P. 40
Removing the Main
Board P. 45
Removing the Carriage
Unit P. 48
Removing the SUB Board
P. 43
Removing the CR Motor
P. 50
Removing the Driven
Pulley Unit P. 53
Removing TPU Lower Housing
P. 54
Removing the DRV
Board P. 61
Removing the Hinges
P. 62
Removing Compression
Spring 3.15 P. 65
Removing the TPU Carriage
Unit P. 55
Removing the TPU CR Motor
P. 63
Removing the TPU Unit
Cable P. 57
Removing the Panel Board
P. 44
Removing the SUB_B Board and
TPU Inverter Board P. 58
Removing the SUB_C Board,
SUB_D Board and Lamps P. 59
Removing the TPU Unit
P. 39