Epson PERFECTION V700 PHOTO - Removing the Carriage Unit

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 48
4.2.6 Removing the Carriage Unit
1. Remove the Front Cover.
See Step 1 to Step 2 in Section 4.2.4
2. Move the Carriage Unit to the centre.
See Step 2 in Section 4.2.5
3. Remove the 5 mm hex nut that secures the Carriage Shaft.
4. Remove the C.B.P. M3 x 10 screw that secures the Ground Plate B
and remove it from the Carriage Shaft.
Figure 4-23. Removing the Carriage Shaft (1)
5. Rotate the Carriage Shaft with a wrench or similar tool so that the
edge of the shaft can come out from the bushing.
Figure 4-24. Removing the Carriage Shaft (2)
Front of the Scanner
Hex Nut (5 mm)
(9±1 kgf.cm)
Carriage Shaft Hex Nut
Ground Plate B
Carriage Shaft
Ground Plate B
C.B.P. M3x10
(6±1 kgf.cm)
Rotating the Carriage Shaft