Epson PERFECTION V700 PHOTO - Removing the TPU Carriage Unit

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 55
4.2.10 Removing the TPU Carriage Unit
1. Remove the TPU Lower Housing. See Section 4.2.9 on page 54.
2. Move the TPU Carriage Unit to the centre.
Figure 4-37. Centering the TPU Carriage Unit
3. Remove the TPU Carriage Shaft according to the following procedure.
1. Remove the TPU Carriage Shaft from the Rear Bushing of the
TPU Upper Housing.
2. Pull the TPU Carriage Shaft out of the Front Bushing of the TPU
Upper Housing.
3. Pull the TPU Carriage Shaft out of the TPU Carriage Unit
toward the rear to remove it.
Figure 4-38. Removing the TPU Carriage Shaft
TPU Carriage Unit
1
Rear Bushing
2
3
Front Bushing
TPU Carriage Shaft