Epson PERFECTION V700 PHOTO - Removing the TPU Unit Cable

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 57
4.2.11 Removing the TPU Unit Cable
1. Remove the TPU Lower Housing. See Section 4.2.9 on page 54.
2. Remove the C.B.P. M3 x 8 screw that secures the grounding wire of
the TPU Unit Cable.
3. Disconnect the TPU Unit Connector CN2 from the DRV Board and
remove the TPU Unit Cable.
Figure 4-43. Removing the TPU Unit Cable
C.B.P. M3x8
(6±1 kgf.cm)
TPU Unit CableDRV Board
TPU Unit
Connector CN2
Connect the TPU Unit Cable to the DRV Board following the
procedure given below.
1. Connect the TPU Unit Cable to the DRV Board.
2. While slightly lifting the DRV Board, insert the
grounding wire of the TPU Unit Cable between the
DRV Board and TPU Upper Housing.
3. Secure the grounding wire of the TPU Unit Cable with
the screw together with the DRV Board.
4. Place the TPU Unit Cable onto the notch of the TPU
Upper Housing.
Figure 4-44. Connecting the TPU Unit Cable
Notch
TPU Unit Cable
Grounding
DRV Board