Epson PERFECTION V700 PHOTO - Detailed Setting Instructions

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 59
7. Release the five tabs that secure the Protective Sheet and remove the
TPU Inverter Board.
Figure 4-48. Removing the TPU Inverter Board (2)
4.2.13 Removing the SUB_C Board, SUB_D Board and
Lamps
1. Remove the TPU Inverter Board. See Section 4.2.12 on page 58.
2. Remove the TPU Lamp Cover using the following procedure.
1. Release all cables from their retaining tabs shown in the figure
below.
2. Remove the two C.B.P. M3 x 6 screws that secure the TPU
Lamp Cover to remove it.
Figure 4-49. Removing the TPU Lamp Cover
 Refer to Figure 4-45 when attaching the Protective
Sheet to the TPU Inverter Board.
 When installing the SUB_B Board, match the
positioning holes and the guide pins as shown in Figure
4-45.
 When installing the LED Cover to the SUB_B Board,
match the positioning holes and the guide pins as
shown in Figure 4-45.
Tabs
Tabs
Protective Sheet
TPU Inverter Board
Tabs
C.B.P. M3x6
(6±1 kgf.cm)
Positioning Hole
and Guide Pin
C.B.P. M3x6
(6±1 kgf.cm)
Positioning Hole
and Guide Pin
Connector Cables
TPU Lamp Cover