Epson PERFECTION V700 PHOTO - Removing the CR Motor

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 50
4.2.7 Removing the CR Motor
1. Remove the Carriage Unit. See Section 4.2.6 on page 48.
2. Disconnect the CR Motor Connector from the CR Motor Relay
Connector.
3. Remove the C.B.P. M3 x 10 screw and C.B.P. M3 x 8 screw that
secure the FFC Cover and remove the FFC Cover.
4. Remove the C.P.F.P. M3 x 8 screw that secures the Harness B Cover
and remove the Harness B Cover.
5. Remove the two C.B.P. M3 x 10 screws, C.B.P. M3 x 10 screw and
C.P.F.P. M3 x 8 screw that secure the Motor Harness Cover.
6. Disconnect the CR Motor Relay Connector (CN9) from the Main
Board and remove the Motor Harness Cover.
7. Remove the C.B.P. M3 x 10 screw that secures the CR Motor Unit.
8. Remove the CR Drive Belt from the Driven Pulley and remove the
CR Motor Unit.
Figure 4-27. Removing the CR Motor Unit
C.P.F.P. M3x8 (7±1 kgf.cm)
C.B.P. M3x10 (7±1 kgf.cm)
C.B.P. M3x8 (7±1 kgf.cm)
Driven Pulley
CR Drive Belt
Positioning Hole and Guide Pin
Ferrite Core Locking Tab
CR Motor UnitCR Motor ConnectorMotor Harness Cover
CR Motor Relay Connector (CN9) FFC Cover Harness B Cover