Epson PERFECTION V700 PHOTO - Scanning in Home Mode

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 51
9. Remove the CR Drive Belt from the CR Motor Unit following the
procedure below.
1. Release the end A of Torsion Spring 121 from the tab on the CR
Motor Holder, and remove the Torsion Spring 121 from the shaft
of the CR Motor Holder.
2. Remove the C.B. M3 x 3 screws and P.W. M3 x 0.8 screws that
secure the Tension Holder, then remove the Tension Holder and
Pulley.
3. Remove the CR Motor Belt, and then remove the CR Drive Belt.
Figure 4-28. Removing the CR Drive Belt
10. Remove the E-ring that secures the Driven Pulley and remove the
Driven Pulley.
11. Remove the three hex-nuts (H.N.-2, 3), then remove the CR Motor,
and three Motor Insulators.
Figure 4-29. Removing the CR Motor
C.B. M3x3
(6±1 kgf.cm)
Pulley
Tension Holder
P.W. M3x0.8
(6±1 kgf.cm)
End A and tab
Torsion Spring 121 and shaft
CR Motor Belt
CR Drive Belt
Motor Insulator
Hex-nuts (H.N.-2, 3)
(5.5±0.5 kgf.cm)
E-ring
CR Motor
Driven Pulley