Epson PERFECTION V700 PHOTO - Removing Compression Spring 3.15

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 65
4.2.17 Removing Compression Spring 3.15
1. Remove the TPU CR Motor Unit. See Section 4.2.16 on page 63.
2. Remove the two C.P.F.P. M3 x 8 screws that secure the TPU Driven
Pulley Unit, and remove the unit together with the Compression
Spring 3.15.
3. Remove the Compression Spring 3.15 from the TPU Driven Pulley
Unit.
4. Remove the E-ring and then remove the Driven Pulley from the
Driven Pulley Unit
Figure 4-65. Removing Compression Spring 3.15
 Install the four TPU CR Motor Dampers as shown in
the figure below.
Figure 4-63. Installing the TPU CR Motor Dampers
 Route the TPU CR Motor Cable through the notch as
shown in the figure below.
Figure 4-64. Routing the TPU CR Motor Cable
A D J U S T M E N T
R E Q U I R E D
Whenever the TPU Tension Holder or the TPU CR Motor
Holder is replaced, G-26 grease must be applied to the
specified points.
See Figure 6-4 on page 70 .
TPU CR Motor Damper
Notch
TPU CR Motor Cable
C A U T I O N
When performing the next step, watch out for Compression
Spring 3.15 as it may pop up.
C.P.F.P. M3x8
(6±1 kgf.cm)
E-ring Driven Pulley TPU Driven Pulley Unit
Compression Spring 3.15