Epson PERFECTION V700 PHOTO - Scanning in Professional Mode

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 53
4.2.8 Removing the Driven Pulley Unit
1. Remove the CR Drive Belt from the Driven Pulley.
See Step 1 to Step 8 in Section 4.2.7
2. Remove the two C.P.F.P. M3 x 8 screws that secure the Driven
Pulley Unit, and remove the Driven Pulley Unit and the Driven
Pulley Spring.
3. Remove the Driven Pulley Spring from the Driven Pulley Unit.
Figure 4-33. Removing the Driven Pulley Unit
4. Remove the E-ring and then remove the Driven Pulley from the
Driven Pulley Unit.
Figure 4-34. Removing the Driven Pulley
C.P.F.P. M3x8
(7±1 kgf.cm)
Driven Pulley Unit Driven Pulley Spring
Rib of the Driven
Pulley Holder
Insert the Driven Pulley Spring into the Lib of the Driven
Pulley Holder.
A D J U S T M E N T
R E Q U I R E D
Whenever the Driven Pulley Holder is replaced, G-26 grease
must be applied to the specified points.
See Figure 6-1 on page 70 .
E-ring Driven Pulley
Driven Pulley Holder