Epson PERFECTION V700 PHOTO - Removing the DRV Board

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 61
4.2.14 Removing the DRV Board
1. Move the TPU Carriage Unit to the centre.
See Section 4.2.10 on page 55.
2. Remove the TPU Unit Cable. See Section 4.2.11 on page 57.
3. Remove the two C.B.P. M3 x 8 screws that secure the DRV Board
Cover and remove it.
Figure 4-53. Removing the DRV Board Cover
4. Disconnect the TPU Motor cable from connector CN3, and the
DRV-SUB_B FFC from CN4 on the DRV Board, and remove the
DRV Board.
Figure 4-54. Removing the DRV Board
DRV Board Cover
C.B.P. M3x8
(6±1 kgf.cm)
C.B.P. M3x8
(6±1 kgf.cm)
Positioning Hole and Guide Pin
 When installing the DRV Board, match the positioning
holes and the guide pins as shown in Figure 4-54.
 When installing the DRV Board Cover, match the
positioning holes and the guide pins as shown in Figure
4-53.
Positioning Hole and Guide Pin
TPU Motor
Connector CN3
DRV-SUB_B FFC CN4
DRV Board