Epson PERFECTION V700 PHOTO - Removing the SUB_B Board and TPU Inverter Board

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 58
4.2.12 Removing the SUB_B Board and TPU Inverter
Board
1. Remove the TPU Carriage Unit. See Section 4.2.10 on page 55.
2. Remove the C.B.P. M3 x 8 screw that secures the LED Cover and
remove it.
3. Remove the C.B.P. M3 x 8 screw that secures the SUB_B Board.
Figure 4-45. Removing the SUB_B Board (1)
4. Lift the SUB_B Board and disconnect the Connectors CN2, CN3,
and CN4. Release the cables from the retaining clip on the TPU
Lamp Cover, and remove the SUB_B Board.
Figure 4-46. Removing the SUB_B Board (2)
5. Remove the two C.B.P. M3 x 6 screws that secure the TPU Inverter
Board Unit.
6. Disconnect the Connectors CN1, CN2, and CN3 from the TPU
Inverter Board and remove the TPU Inverter Board Unit.
Figure 4-47. Removing the TPU Inverter Board (1)
Positioning Hole and Guide Pin
LED Cover
C.B.P. M3x10
(6±1 kgf.cm)
Cables and Retaining Clip
CN3
CN4
CN2
C.B.P. M3x6
(6±1 kgf.cm)
TPU Inverter Board Unit
CN2
CN1
CN3