Epson PERFECTION V700 PHOTO - Removing the Hinges

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 62
4.2.15 Removing the Hinges
1. Remove the TPU Lower Housing. See Section 4.2.9 on page 54.
2. Remove the four C.B.P. M4 x 12 screws that secure the Right and
Left Hinges and remove them.
Figure 4-55. Removing the Hinges
When installing the Hinges, match the positioning holes and
the guide pins as shown in Figure 4-55 .
Positioning Hole
and Guide Pin
Left Hinge
C.B.P. M4x12
(9±1 kgf.cm)
Right Hinge