Epson PERFECTION V700 PHOTO - Selecting File Save Settings

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 56
4. Lift the TPU Carriage Unit and remove the TPU CR Drive Belt from
the retaining clip.
Figure 4-39. Removing the TPU CR Drive Belt
5. Remove the Lock Plate that secures the DRV-SUB_B FFC CN1, and
remove the FFC from the TPU Carriage Unit.
6. Disconnect the DRV-SUB _B FFC CN1 from the SUB_B Board and
remove the TPU Carriage Unit.
Figure 4-40. Removing the TPU Carriage Unit
Clip
TPU CR Drive Belt
DRV-SUB_B FFC CN1
SUB_B Board Lock Plate
 When attaching the DRV-SUB_B FFC to the TPU
Carriage Unit, align the positioning line on the FFC as
shown below and secure it with two pieces of two-sided
tape.
Figure 4-41. Attaching the DRV-SUB_B FFC
 Be sure to route the DRV-SUB_B FFC inside the
protrusion of the TPU Carriage Unit as shown in the
figure below.
Figure 4-42. Routing the DRV-SUB_B FFC
Tape Position
Positioning LineDRV-SUB_B FFC
OK
Protrusion
DRV-SUB_B FFC
NG