Epson PERFECTION V700 PHOTO - Scanning in Full Auto Mode

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 46
6. Remove the Ferrite Core from the Lower Main Board Cover.
7. Disconnect the Carriage FFC from CN5 on the Main Board, then
remove the Ferrite Core.
8. Disconnect the Sub Board Connector CN4 from the Main Board.
9. Remove the C.P.F.P. M3 x 8 screw and C.B.P. M3 x 8 screw that
secure the Harness C Cover, and remove the Harness C Cover.
10. Remove the C.P.F.P. M3 x 8 screw that secures the Ground Plate
and remove the Ground Plate.
Figure 4-20. Removing the Main Board (1)
11. Lift the Main Board and disconnect the CR Motor Relay Connector
CN9, then remove the Main Board.
Figure 4-21. Removing the Main Board (2)
Tape Position
Positioning Hole and Guide Pin
Marked Lines
C.P.F.P. M3x8 (7±1 kgf.cm)
C.B.P. M3x8 (7±1 kgf.cm)
SUB Board
Connector (CN4)
Main Board
Carriage FFC (CN5)
Ferrite Core
Harness Cover C
Ground Plate
Main Board
CR Motor Relay
Connector (CN9)