121
Applying Saved Image Shape Settings
You can load the image shape settings you selected and saved to the projector's memory and apply
them to the current image.
1. Turn on the projector and display an image.
2. Hold down the Num button on the remote control and press the number button (1, 2, or 3) that
matches the number of the saved image shape setting.
The saved image shape setting is applied and you are prompted to calibrate the screen.
3. Follow the on-screen instructions to calibrate the screen.
Parent topic: Image Shape
Adjusting the Image Position Using Image Shift
You can use the Image Shift feature to adjust the image position without moving the projector. Wait at
least 30 minutes after you start projecting to adjust the image position.
To Next Page
Loading...
