151
2. Press the Menu button on the projector or remote control.
3. Select the Signal I/O menu and press Enter.
4. Select Inverse Audio and press Enter.
5. Select the setting according to the installation position and press Enter.
• When the projector is mounted to the wall or ceiling, set to On.
• When the projector is placed on a table, set to Off.
6. Press Menu or Esc to exit the menus.
Parent topic: Using Basic Projector Features
Selecting a Quick Startup Setting
If you want to quickly restart the projector within five seconds after turning it off, you can change the
Quick Startup setting. You can select 20, 60, 90 minutes, or Unlimited of Quick Startup time.
Note: The projector may take longer than five seconds to start up in the following conditions:
• When projecting from one of the projector's USB ports
To Next Page
Loading...
