40
3. Connect the other end to the projector's HDBaseT port.
Note: See the documentation that came with the HDBaseT transmitter for instructions on connecting
it to your video device or computer.
4. Turn on the projector and HDBaseT transmitter.
Note: To enable communication from the Ethernet and serial ports on the transmitter, enable Control
Communications in the HDBaseT settings of the projector's Signal I/O menu. Turning on this setting
disables the projector's LAN and RS-232C ports. If you connected an Extron XTP transmitter or switcher
to the projector's HDBaseT port, select On as the Extron XTP setting in the projector's Signal I/O menu.
Parent topic: Setting Up the Projector
Connecting Multiple Projectors of the Same Model
You can project the same image from multiple projectors. You can connect multiple projectors using
either of the following methods:
• Daisy-chain connection
• Distributor connection
You can connect up to four projectors in a daisy-chain connection. You can connect up to four projectors
of the same model in the same room to project a single unified image.
Multiple Projector Connection Menu Settings
Parent topic: Setting Up the Projector
To Next Page
Loading...
