76
The screen sharing function is limited by the following:
• Connect the projectors to the same network as the projector that is sharing images.
• Make sure that no other device is connecting to the projector using the Epson iProjection software.
• Make sure the Screen Sharing setting is set to On.
When the other projector starts sharing screen, the shared screen image is automatically displayed. If
not, press the LAN button on the remote control. To remove the shared image during projection, press
the Esc button.
Parent topic: Screen Sharing
Setting Up Projector Network E-Mail Alerts
You can set up the projector to send you an e-mail alert over the network if there is a problem with the
projector.
Note: If the Standby Mode setting is set to Communication On in the Operation menu, you can
receive e-mail alerts even if the projector is in standby mode (the power is off). The Standby Mode
setting is displayed only if the A/V Output setting in the Signal I/O menu is set to While Projecting.
1. Press the Menu button.
2. Select the Network menu and press Enter.
3. Select Network Settings and press Enter.
Note: If the Remote Password and the Web Control Password have not been set, a screen appears
prompting you to set them. Enter passwords up to 32 characters long. These passwords are used
for accessing the projector over a network, and you do not need to enter them to access the Network
Settings menu after you set them.
4. Select the Mail Notification menu and press Enter.
5. Turn on Mail Notification.
To Next Page
Loading...
