258
Setting Options Description
Standby Mode Communication On
Communication Off
Enable this setting to allow
monitoring and control of the
projector over a network when
the projector is in standby mode;
this setting is only displayed in
the following cases:
• Auto Power On is disabled in
the projector's Network menu
• Auto Power On is not set to
HDMI1 and Power On Trigger
is set to Plug-in Detection
• A/V Output is set to While
Projecting in the Signal I/O
menu
• USB Power is set to On While
Projecting
Parent topic: Adjusting the Menu Settings
Related references
Projector Light Source Specifications
USB Display System Requirements
Your computer system must meet the system requirements here to use the projector's USB Display
software.
Requirement Windows Mac
Operating system Windows 8.x, Pro, and Enterprise (32-
and 64-bit)
macOS 10.13.x (64-bit), macOS
10.14.x (64-bit), macOS 10.15.x (64-
bit), macOS 11.0.x (64-bit), and
macOS 12.0.x (64-bit)
Windows 10 Home, Pro, and Enterprise
(32- and 64-bit)
Windows 11 Home, Pro, Enterprise, and
Education (64-bit)
To Next Page
Loading...
