170
3. Aim the remote control at that projector and press the ID button on the remote control.
The current projector ID is displayed on the screen for about 3 seconds.
4. Hold down the ID button on the remote control while you press the numeric button that matches the
projector's ID. Then release the buttons.
Note: If you select 0/All on the remote control, you can operate all projectors regardless of the
Projector ID setting.
The remote control's ID is set.
Note: If the batteries are left out of the remote control for an extended period, the remote control ID
returns to its default setting.
Parent topic: Projector Identification System for Multiple Projector Control
Adjusting Color Uniformity
If the color tone is uneven on each screen, adjust the color tone balance in the menu of each projector.
(The color tone may not be uniform even after performing color uniformity.)
To Next Page
Loading...
